BallReviews

Equipment Boards => Storm => Topic started by: StormisComin on December 28, 2007, 07:58:53 AM

Title: Cracked Attitude Shift
Post by: StormisComin on December 28, 2007, 07:58:53 AM
i just bought an attitude shift for Christmas and after 1 game the ball has cracked from the ring finger hole to the pin which is less than an inch. what should i do.. going to take it back to the driller tomorrow to see if i can still use it. the crack is a fairly deep one, 1/2 - 3/4 inch. thanks for the help
--------------------
GO YANKEES
GO ORANGE
GO STORM
Title: Re: Cracked Attitude Shift
Post by: NJStroker on December 28, 2007, 04:27:18 PM
Did u use grips?
Title: Re: Cracked Attitude Shift
Post by: StormisComin on December 28, 2007, 04:46:11 PM
yes i used grips

--------------------
GO YANKEES
GO ORANGE
GO STORM
Title: Re: Cracked Attitude Shift
Post by: StormisComin on December 28, 2007, 05:16:11 PM
could i still use it tonite because i have a league @ 9 ????

--------------------
GO YANKEES
GO ORANGE
GO STORM
Title: Re: Cracked Attitude Shift
Post by: TheDude on December 28, 2007, 06:31:04 PM
Actually I haven't had any returns on them, got my drill bits sharpened recently and everything is so much smoother. I always love way they work after they are sharpened.
--------------------
Timothy @Juniors Pro-Shops
LaSalle, Quebec
Located inside Pont Mercier Lanes.
Edmonton, Alberta.
Located inside Ed's Rec Room.(WEST ED MALL)

Keep them honest!
Title: Re: Cracked Attitude Shift
Post by: riggs on December 29, 2007, 04:29:41 AM
When using grips make sure to bevel the finger holes a decent amount - relieves a lot of the stress and makes cracking much less likely! Also, try not to leave them outside if you live in a cold climate.
Title: Re: Cracked Attitude Shift
Post by: charlest on December 29, 2007, 06:26:32 AM
I think that many manufacturers want the pin to be at least 1" from any drilled hole also.
--------------------
"None are so blind as those who will not see."
Unofficial Ballreviews.com FAQ (http://"http://home.mchsi.com/~s-cross-7-28-71/FAQ.htm")
Title: Re: Cracked Attitude Shift
Post by: strikestriketapped on December 29, 2007, 01:48:07 PM
quote:
I think that many manufacturers want the pin to be at least 1" from any drilled hole also.
--------------------
"None are so blind as those who will not see."
Unofficial Ballreviews.com FAQ (http://"http://home.mchsi.com/~s-cross-7-28-71/FAQ.htm")



I think every ball I own is under 1".
--------------------
www.stormbowling.com