BallReviews

Equipment Boards => Storm => Topic started by: Nicanor on December 11, 2008, 07:07:07 AM

Title: Drilling recommendation for a Virtual Gravity and Hyroad
Post by: Nicanor on December 11, 2008, 07:07:07 AM
I just orderes a Virtual Gravity and a Hyroad to go with my Cell pearl, Grand Illusion and Neptue.  I'm looking for drill recommendations for the Hyroad first ball out of the bag and the Virtual Gravity for heavier longer oil.

How far right should the MB be on the Virtual Gravity to allow the ball to start and read the midlane and still have some punch on the back end?

Thanks in advance.



--------------------
Nicanor (Ten On The Deck)
Title: Re: Drilling recommendation for a Virtual Gravity and Hyroad
Post by: TheDude on December 11, 2008, 06:49:47 PM
whats your ball speed and rev rate along with axis rotation?

--------------------
Timothy @Juniors Pro-Shops
LaSalle, Quebec
Located inside Pont Mercier Lanes.
Edmonton, Alberta.
Located inside Ed's Rec Room.(WEST ED MALL)
King Of Roto-Grip In Canada.
Keep them honest!


www.juniorsproshop.com now open serving the world.
Title: Re: Drilling recommendation for a Virtual Gravity and Hyroad
Post by: Nicanor on December 11, 2008, 08:07:23 PM
I should have added the info.  

ball speed  17 mph
rev rate about 350-400
lower ball track but not low, about 1 1/2 inches to 2 inches left of middle finger and thumb
pap  4 7/8 and 5/8 up.

Would appreciate some advice.

Thanks,

--------------------
Nicanor (Ten On The Deck)
Title: Re: Drilling recommendation for a Virtual Gravity and Hyroad
Post by: LaneHammer20 on December 11, 2008, 10:00:44 PM
I have not thrown the ball but from what i ahve heard and your stats.

5X4 sounds like a good choice. Alot of people are drilling it past 5 inches pin to PAP and see the strongest ball they have thrown.

4 1/2 X 4 1/2 might be a choice but I have similar revs as you and I think that would be overkill.
--------------------
What is sandbagging???