win a ball from Bowling.com

Author Topic: How to drill agent  (Read 736 times)

xxZonexx

  • Hero Member
  • *****
  • Posts: 1095
How to drill agent
« on: February 13, 2008, 05:38:49 AM »
Getting a nib agent soon looking to add it to my arsenal.So far i have

Specail Agent Pin under ring cg 45 deg, Flare increasing X hole
Domination pin above ring mb in strong position, X hole on pap
Spit Fire Pin above and to the right of the ring finger cg in palm, no x hole
Jolt Pearl Pin under fingers cg out tword axis X hole down on val.

Other balls
Complete Nv, pin under ring mb 45 deg, x hole in finger quad.
Hammer No Mercy Drilled using the Recomended drilling. pin next to fingers cg on grip center, mb left of the thumb.

How should i drill this agent, i threw some one elses and i liked it so thats the only reason why im buying one. The only thing im lacking is A ball with the pin over the bridge or one with the pin under middle finger... Not sure any sugestions

Power stroker
16.5 mph
300 revs
Lower track
Pap is 4 1/2 over 1/4 up
bowling on synthetic lanes

--------------------
Storm
Specail Agent
Domination
Spit Fire (4.5 x 5)
Jolt Pearl

 

coltfoet5

  • Full Member
  • ***
  • Posts: 143
Re: How to drill agent
« Reply #1 on: February 13, 2008, 02:30:10 PM »
Drill it leverage, get some good mid lane and backend. I would go 3 3/8" with the Pin with the cg stacked and a skinnier/deeper hole.
--------------------
Check the new Bowling site and forums!
http://www.newballz.com
http://www.newballz.com/forum
Being updated daily
Check the new Bowling site and forums!
http://www.newballz.com
http://www.newballz.com/forum
Being updated daily