BallReviews
Equipment Boards => Storm => Topic started by: River700 on January 27, 2010, 01:42:58 PM
-
Hi everyone. I have a 15 lb storm original hot rod with a 3 1/4 inch pin with the pin right under the ring with the cg on top of the thumb hole and a pinch to the right. Well, it does role really smooth, but I would like it to rev up just a little easier than it does. So what size of weight hole should I use and where should I put it? My pap is 5 1/2 over by 3/8's up. Currently it has 1/2 ounce side and 1/2 ounce thumb weight.
--------------------
Bowling is fun, enjoy it, don''t hate it
-
http://www.morichbowling.com/Drilling/GradientLineBalanceHole/GradientLineBalanceHole.htm
P4 position is probably what you're looking for, but will depend on what you can do, while keeping it legal.
--------------------
Mega Friction 278
Virtual Gravity 272
Twisted Fury 268
The Sauce 255
FS/FT Rogue Cell
FS/FT Black Widow Solid
FS/FT Kinetic Energy
-
Hi Adrenaline, thanks for the info. I have looked at the morich extra hole guide and was possibly thinking an extra hole in the p3 spot. However, I am still not sure though, it's not like I want the ball to hook more, just rev up a bit easier.
--------------------
Bowling is fun, enjoy it, don't hate it
-
Go with the P3 then. I put a P4 on my BW Bite and it made a pretty big difference. I added a P3 to my Creature because I needed a bit more flare (opened up the flare rings more than anything) but didn't want to change the general character of the ball. Start relatively small (1/2-5/8") and go bigger if you want.
--------------------
Penn State Proud
Ron Clifton's Bowling Tip Archive (http://"http://www.bowl4fun.com/ron/roncarchive.htm")
-
Thanks Strider. that's kind of what I am leaning to is the hole in the p3 spot. I am going to talk to my driller and see what he thinks and go from there.
--------------------
Bowling is fun, enjoy it, don't hate it