BallReviews

Equipment Boards => Track => Topic started by: Rock77 on August 27, 2003, 09:29:17 PM

Title: Drilling my Phenom
Post by: Rock77 on August 27, 2003, 09:29:17 PM
Drilling my Phenom tonight and am still not sure how. It has a 2" pin and 3 oz. of top weight. According to the drilling pamphlet that came with the ball. I was going to use the low track drilling with pin position 3 and MB position 3. That would put the pin below and to the right of ring and the MB would be pretty much on my VAL. I assume a weight hole will be needed. According to the back of the drill pamphlet, the reaction type should be similar to #3. What do you guys think?? Please voice your opinions.
--------------------
How am I supposed to knock all 10 down with one ball?!?
Title: Re: Drilling my Phenom
Post by: stanski on August 31, 2003, 10:34:48 PM
really strong ball. be cautious with how u drill it. i have mine pin above finger mb under thumb and the thing still hooks a ton. it doesnt ever roll out tho and hits the rack with a ton of power
--------------------
stanski
Title: Re: Drilling my Phenom
Post by: Rock77 on September 01, 2003, 12:08:30 AM
quote:
really strong ball. be cautious with how u drill it. i have mine pin above finger mb under thumb and the thing still hooks a ton. it doesnt ever roll out tho and hits the rack with a ton of power
--------------------
stanski


Drilled it already, pin under ring, mb to the right almost on my VAL. Lots of ball, lots of power. This ball moves!! I like it!!
--------------------
How am I supposed to knock all 10 down with one ball?!?
Title: Re: Drilling my Phenom
Post by: Rock77 on September 01, 2003, 12:08:55 AM
quote:
really strong ball. be cautious with how u drill it. i have mine pin above finger mb under thumb and the thing still hooks a ton. it doesnt ever roll out tho and hits the rack with a ton of power
--------------------
stanski


Drilled it already, pin under ring, mb to the right almost on my VAL. Lots of ball, lots of power. This ball moves!! I like it!!
--------------------
How am I supposed to knock all 10 down with one ball?!?
Title: Re: Drilling my Phenom
Post by: TheGom on September 01, 2003, 01:30:03 AM
Is the info that comes with the ball different than what they show on their web site, which shows no MB......Del's ball says it is drilled 3.5 and 5 to MB I don't see a MB on those pattern online.......thanks BG
Title: Re: Drilling my Phenom
Post by: C-G ProShop-Carl on September 01, 2003, 01:46:25 AM
The drill pattern on the website is wrong.....I think if you actually pay attention it will say something on the Phenom page about it being the Crunch page. The drilling for the Phenom is like the drilling for the Freak, FreakOut, Mutant, and Super Freak.