win a ball from Bowling.com

Author Topic: layout for AMB Immortal Solid  (Read 848 times)

J_w73

  • Hero Member
  • *****
  • Posts: 2554
layout for AMB Immortal Solid
« on: December 10, 2008, 09:38:03 AM »
I gave up on my Immortal Solid but have decided to give it another chance.
Not even sure if the problem is the layout but I am going to plug it and redrill it with a new layout.
current layout.
5 inch pin to pap.. pin slightly right of and 1 inch above ring finger( I would say 20-30 deg to VAL).
70 deg mb right next to thumbhole

I'm thinking the VAL angle is too small and the MB drill angle is too big.

Any recommendations.

stats.
PAP 5 1/2 and 3/8 up
speed 16-17 mph
RPM- 350 - 475
like to play 3rd arrow out to 10,9,8.
like to stay in the oil and not use wall on THS
350 RPM, 17 MPH

 

I_Bowl4Money

  • Hero Member
  • *****
  • Posts: 677
Re: layout for AMB Immortal Solid
« Reply #1 on: December 15, 2008, 09:58:59 AM »
5 1/2 Pin to PAP

This should fall above your bridge

80 Drill Angle
60 Val Angle
--------------------
Stephen Hahn

  • http://www.bowl4money.com/what.html - Visionary Arsenal

  • http://www.bowl4money.com (Personal Site)

  • http://www.sparesproshop.com (Staff)

  • http://www.row-del.com (Staff)


  • Stephen Hahn
    PBA Professional
    Brunswick Regional Staffer
    VISE Regional Staffer

    J_w73

    • Hero Member
    • *****
    • Posts: 2554
    Re: layout for AMB Immortal Solid
    « Reply #2 on: December 15, 2008, 12:43:46 PM »
    so you think i should have the MB drill angle larger?
    putting the pin 5.5 inches from my pap and above the bridge would put the VAL angle at 45 deg..
    Also, an 80 deg MB drill angle would put the virtual mass bias in the thumb hole.
    350 RPM, 17 MPH