Author Topic: venom drilling (Read 1880 times)

VAbowler · « **on:** March 08, 2006, 10:45:18 AM »

I'm about to get one, was wondering how to drill it up.. I want to create area w/this ball, be able to swing it, maybe pin about 1 1/2 inches right next to ring finger, mb 2 inches right? Any suggestions?

VAbowler · « **Reply #1 on:** March 08, 2006, 09:33:25 PM »

any input would help

BeansProShop · « **Reply #2 on:** March 08, 2006, 10:01:42 PM »

Get a 3-4 inch pin and drill the ball 4x4 with the MB in the strong position. X-hole if needed........Amazing layout on all my bell core balls
--------------------
Thomas "Beans" Biniek Jr.
PBA Member and Lane#1 Pro Staff Member
Thanks for reading and be sure to check out my current eBay auctions at:
http://cgi6.ebay.com/ws/eBayISAPI.dll?ViewSellersOtherItems&userid=bubby856

Official Pro Shop of "ALL" F.O.S. Members!!!

VAbowler · « **Reply #3 on:** March 08, 2006, 10:23:17 PM »

thanks for the input, can you elaborate on 4x4? So pin is above, below, or lined up w/fingers? can you describe the reaction?

OnTheFly · « **Reply #4 on:** March 08, 2006, 11:53:09 PM »

If you want the ball to roll later and have a quicker response to the dry put the pin above the fingers. If you want the opposite which is to roll earlier and react smoother to the dry put the pin below the fingers. Remember weight holes in the ball will also aid in the amount of flare you would like to produce, but that is a whole other topic. I hope this helps.
--------------------
Nathan Michalowski
AMF300 PBA Regional Staff
Vise-Grip Pro Staff
OnTheFly@aol.com

Author Topic: venom drilling (Read 1880 times)

VAbowler

venom drilling

VAbowler

Re: venom drilling

BeansProShop

Re: venom drilling

VAbowler

Re: venom drilling

OnTheFly

Re: venom drilling