Author Topic: flaring over finger (Read 1666 times)

86camaroman · « **on:** December 08, 2009, 02:24:00 AM »

I drilled a ball for my friend the pin is basically in the middle of the bridge below the fingers he is clipping the finger the last few feet down the lane. where can i put an axis hole to fix this for him.

JustRico · « **Reply #1 on:** December 09, 2009, 08:56:29 AM »

I would recommend going 2 1/2" down his VAL to push the bow tie up and away from his middle finger.
--------------------
Formerly BrunsRico

86camaroman · « **Reply #2 on:** December 09, 2009, 08:59:38 AM »

how deep and what size bit

JohnP · « **Reply #3 on:** December 09, 2009, 09:29:24 AM »

When determining balance hole size and location you have to be sure the static weights will end up legal. So to be sure of any recommendation we would have to know what the existing static weights are. -- JohnP

T-GOD · « **Reply #4 on:** December 09, 2009, 09:37:33 AM »

Usually the pin controls the flare and would need to be placed higher up. Of course, a re-drill would be necessary to do that.

A low hole, as ric stated might move the bow tie up a touch, but I don't think that's a guarantee to stop hitting the finger hole. Good luck. =:^D

86camaroman · « **Reply #5 on:** December 09, 2009, 02:12:48 PM »

bout 3/4 of an ounce thumb and side weight so should be able to about any size weight hole

JohnP · « **Reply #6 on:** December 10, 2009, 09:58:34 AM »

Then JustRico's suggestion is your best bet. -- JohnP

Author Topic: flaring over finger (Read 1666 times)

86camaroman

flaring over finger

JustRico

Re: flaring over finger

86camaroman

Re: flaring over finger

JohnP

Re: flaring over finger

T-GOD

Re: flaring over finger

86camaroman

Re: flaring over finger

JohnP

Re: flaring over finger