win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Layout for spare ball  (Read 13718 times)

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Layout for spare ball
« on: August 19, 2003, 02:46:24 AM »
I have ordered a plastic Columbia ball for a spare ball.  I am a low speed (13 mph) stroker.  I want the ball to break as little as possible using my normal release (high three quarter roller).  I don't care if it rolls on the finger or thumb holes.  I'm thinking either place both the pin and cg between the grip centerline and the track or place the pin on the pap and the cg as close to grip centerline as possible and drill back to negative side weight.  Any thoughts on these layouts or other, better suggestions?  Thanks.  JohnP
Logged

 

mumzie

  • Hero Member
  • *****
  • Posts: 6914
Re: Layout for spare ball
« Reply #1 on: August 19, 2003, 05:49:16 PM »
I don't know about Columbia, but my Brunswick spare ball doesn't have a pin. The CG is marked, and the drilling is straight up.
Logged
------------------------
www.Shirts4Bowling.com
We Know What Bowlers Want

Home of the HAMBONE shirt!

Belgarion

  • Hero Member
  • *****
  • Posts: 559
Re: Layout for spare ball
« Reply #2 on: August 19, 2003, 05:54:51 PM »
if it is a white dot...dead over the lable is fine.  If not, try to go negative and maybe even move the pin towards the track with the cg in the center.
Logged

charlest

  • Hero Member
  • *****
  • Posts: 24523
Re: Layout for spare ball
« Reply #3 on: August 19, 2003, 09:38:37 PM »
As others have already said, in general, the drilling of a hard plastic ball should make little difference.

If you wish to minimize the reaction, you can drill it with maximum negative side weight (1 oz) and maximum thumb weight (1 oz) that can be done with that ball. This will make the ball go into a roll as soon as possible and will minimize the hook. Your driller should know how to do this.
--------------------
"Those who do not remember history are doomed to repeat it."
Logged
"None are so blind as those who will not see."

charlest

  • Hero Member
  • *****
  • Posts: 24523
Re: Layout for spare ball
« Reply #4 on: August 20, 2003, 02:11:02 PM »
quote:
if it is a white dot...dead over the lable is fine.  If not, try to go negative and maybe even move the pin towards the track with the cg in the center.


pin placement on true pancake core balls such as White Dots and Maxims has no effect. Only the CG movement/placement and subsequent side/finger-thumb/top-bottom weighting has an effect.
--------------------
"Those who do not remember history are doomed to repeat it."
Logged
"None are so blind as those who will not see."

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Re: Layout for spare ball
« Reply #5 on: August 20, 2003, 11:06:14 PM »
It is a white dot, and you are right.  It came in, and the pin (had to look very carefully to find it at all) is on the bottom of the ball.  I'm not going to drill it for a couple of weeks -- I'm changing weights from 16 lb to 14 lb, and don't want to do the spare ball until my new strike ball comes in.  I'm planning to use about 3/4 oz of neg side wt and see what it does.  I'll post results when I've had a chance to get used to it.  Thanks for the input.  -- JohnP
Logged
Pages: [1]
« previous next »