win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Long pin drilling ...?  (Read 1629 times)

sawman1

  • Full Member
  • ***
  • Posts: 193
Long pin drilling ...?
« on: October 06, 2003, 08:42:46 PM »
I picked up a nib Brunswick Raging Red Fuze with a pin of 4.5-5".  Just wondering if it's junk, or can I get a decent drilling on it.  If so, what kind of reactions can I expect?  All suggestions welcome.
Logged

 

T-GOD

  • Hero Member
  • *****
  • Posts: 2141
Re: Long pin drilling ...?
« Reply #1 on: October 07, 2003, 03:41:38 PM »
If you're looking for a smoother, yet strong reaction, I would drill it CG on PAP, hole on PAP, with the pin just over fingers. This will give you the best reaction in my opinion. =:^D
Logged

RSalas

  • Hero Member
  • *****
  • Posts: 4058
Re: Long pin drilling ...?
« Reply #2 on: October 07, 2003, 03:55:53 PM »
For you drilling gurus out there...

Just out of curiosity, what kind of reaction would result if the pin were put on the PAP, with the CG in or near the palm?
Logged
#TweetYourScores

1fife

  • Hero Member
  • *****
  • Posts: 1411
Re: Long pin drilling ...?
« Reply #3 on: October 07, 2003, 04:10:19 PM »
roll early-minimxed backend

low flaring
--------------------
Dont swing it-if you cant bring it

When in doubt-swing it out
Logged

sawman1

  • Full Member
  • ***
  • Posts: 193
Re: Long pin drilling ...?
« Reply #4 on: October 07, 2003, 07:40:55 PM »
Thanks!!  That helps a lot.
Logged
Pages: [1]
« previous next »