Great chart, thanks, but it doesn't specify whether it's past the VAL. One could assume that the 0 degree is on PAP and on VAL...
The chart is just a generalist. Your 75 degree drilling won’t look exactly like my 75 degree drilling. It is just a rough chart to give you an idea of what to expect from a drilling of that angle for your individual specs.
The mb is 6 3/4 inches from the pin. Unless your pap is almost 7 over, it would have to be past the Val, unless you drilled a long pin out ball with the pin far enough from the pap to compensate for it. I don’t think I have ever seen anybody drill a ball with a seven inch pin to pap though.
The KI solid I had had the cg on the pap, drilled back to static legal, with the mb past the val. Real smooth and rolly reaction.
If your pap is 7 over, to me, that ain’t normal. Most are in the 4 1/2 to 5 1/2 over range. I suppose it’s possible, I just haven’t ever seen that.
Short of that, 0 degrees would HAVE to put the mb past the Val, wouldn’t it?