win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Crisis Pearl Drilling Ideas  (Read 1002 times)

AllAirForceTwice

  • Sr. Member
  • ****
  • Posts: 461
Crisis Pearl Drilling Ideas
« on: December 23, 2004, 01:02:16 PM »
If someone could read my review of the Vendetta Pearl and give me an opinion on drilling The Crisis Pearl to compliment it I would appreciate it.

Also, has anyone thrown the Crisis Pearl on blown heads/track like the last game of a Sport League... What did it do?
Logged
Dave Ingraham, Major, USAF (Ret)

 

jimensminger

  • Hero Member
  • *****
  • Posts: 1846
Re: Crisis Pearl Drilling Ideas
« Reply #1 on: December 30, 2004, 06:08:58 AM »
Dave,..I have a Crisis Pearl drilled with the pin above and to the right of the finger hole, cg is about 1/2" on the pos side of the midline on the midline. Surface was taken down with wet green scotch bright on a spinner, then came back with B'wick 800 factory polish to a good sheen. This ball is very smooth, and hard arcing, playing in when there's a burnt track. It doesn't jump off the dry,..which I really like. I changed the surface because the factory polish seemed to make the ball a little jerky. jim
--------------------
www.dynothane.com
Logged

AllAirForceTwice

  • Sr. Member
  • ****
  • Posts: 461
Re: Crisis Pearl Drilling Ideas
« Reply #2 on: December 31, 2004, 02:10:53 PM »
Thanks! I was hoping you had already experimented with changing the surface.
Logged
Dave Ingraham, Major, USAF (Ret)

jimensminger

  • Hero Member
  • *****
  • Posts: 1846
Re: Crisis Pearl Drilling Ideas
« Reply #3 on: December 31, 2004, 03:59:56 PM »
call me crazy,..but only about 1 out of 3 balls I get from the factory get to keep their factory surface,...the Crisis Pearl surface (for me) was way too shiny...
--------------------
www.dynothane.com
Logged
Pages: [1]
« previous next »