I just recieved  a One.  I havent thrown ebonite in a long time but was actually impressed with this ball so got one for cheap.  I know the ball comes with a drilling label on it and instructions but I was expecting a pin of 3-4 inches but instead recieved one that has a 2 inch pin.  I'm curious as to whether this short pin will affect the ability to lay it out with the pin above the fingers in reguard to the late back end reaction.  I'm thinking it should be ok but just wanted to know what your opinions were or possible recommend another drilling.

Thanks,
Nick
--------------------
In a terrible slump now.  Average is down 20 pins over last year because I can't carry anything.  Not even Dyno-Thane can help.

 
 Use layout #1 and you'll have no problems.

 With layout #1 it shouldnt be a negative cg. #1 puts the MB 3" from the thumb. Is it that far out of line?
--------------------
Manfred von Richthoffen for  moderator!!!
 

I actually measured the location of the MB inrelation to where the pin and cg are and it's right at 3 inches exactly so should be no problem.  Thanks for the help everyone
--------------------
In a terrible slump now.  Average is down 20 pins over last year because I can't carry anything.  Not even Dyno-Thane can help.