win a ball from Bowling.com

Author Topic: big blue pearl drilling  (Read 1341 times)

lilphyzx

  • Sr. Member
  • ****
  • Posts: 368
big blue pearl drilling
« on: December 26, 2004, 10:50:27 PM »
Hey fellas I just purchased a big blue pearl and what do you guys think of a stack drill with pin over ring and cg in the palm. What reaction should I get with the big blue and do you have any other suggestions to make this ball versatile.

 

anotherwindup

  • Hero Member
  • *****
  • Posts: 740
Re: big blue pearl drilling
« Reply #1 on: December 27, 2004, 02:03:40 PM »
I have 2.

1)  5 1/2" Pin to PAP.   LMB in track area.   Ball is very clean through the fronts and makes a nice hard arc to the pocket.  

2)  5" Pin to PAP  LMB below the thumb on the midline of grip.   Ball is very clean and very jerky at the dry.    

I would use long pin drillings on this ball and if you want/need and earlier rolling ball then use an early drill on a Big Blue solid or get a Power Diesel.  

This ball is very good.


--------------------

Jason Jenkins
"Nothing HITS like a Hammer"

lilphyzx

  • Sr. Member
  • ****
  • Posts: 368
Re: big blue pearl drilling
« Reply #2 on: December 28, 2004, 07:24:26 AM »
Thanks I have something to go on. I want to get something a little different from everything else i have. I dont have a particle pearl so that is one thing.

bigearv14

  • Hero Member
  • *****
  • Posts: 1545
Re: big blue pearl drilling
« Reply #3 on: December 29, 2004, 10:07:30 PM »
i have one pin over ring and mb in strong position
this thing goes very long and snaps.
excellent angle and carry