win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Changing No Mercy Surface  (Read 966 times)

wlee107

  • Jr. Member
  • **
  • Posts: 34
Changing No Mercy Surface
« on: November 16, 2006, 11:51:19 AM »
Hello everyone! I just recently purchased a 14# No mercy. When i first threw it the ball just went too long before hooking. I've tried at all angles, but it just goes too long! I've kept it at 4000 abralon. Any suggestions on changing the surface so that it reduces length? Thanks.
--------------------
Hammer No Mercy 14#
Brunswick Power Groove 12#
Brunswick Zone 16#
Logged

 

six pack

  • Hero Member
  • *****
  • Posts: 2799
Re: Changing No Mercy Surface
« Reply #1 on: November 16, 2006, 07:59:46 PM »
mine is at 1000 grit abralon and it's all rolly,rolly,rolly man.I used to sand on a spinner but found that the ball came out more in a polished state.I've recently discovered hand sanding in abralon, works great.
--------------------
B-dub in the house YE'all..
Logged
The harder I try the harder they fall

wlee107

  • Jr. Member
  • **
  • Posts: 34
Re: Changing No Mercy Surface
« Reply #2 on: November 16, 2006, 08:28:13 PM »
Thanks! I'll try 1000 grit on saturday and i'll see what happens. ITS JUST GOING TOO LONG RIGHT NOW!!! But the ball has tremendous hitting power...
--------------------
Hammer No Mercy 14#
Brunswick Power Groove 12#
Brunswick Zone 16#
Logged
Pages: [1]
« previous next »