win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: PIN & TOP WEIGHT?????  (Read 1213 times)

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
PIN & TOP WEIGHT?????
« on: June 11, 2003, 12:13:43 PM »
I am getting ready to purchase a ball that will be drilled stacked leverage (3 3/8 X 3 3/8). What I need to know is there a preferred pin and top weight for this type of drilling?

Me: RH, stroker,15-17mph, low to med revs, low axis tilt, 30°-45° axis rotation, usually play between 10-15 arrows and 7-11 break point.
Logged

 

Jeffrevs

  • Hero Member
  • *****
  • Posts: 11890
Re: PIN & TOP WEIGHT?????
« Reply #1 on: June 12, 2003, 07:16:00 AM »
Personally, I would find a 3 and 3. Meaning, 3 inch pin to cg and a 3 oz. top.

Good luck.......
--------------------
JEFF
Logged

Goof1073

  • Hero Member
  • *****
  • Posts: 2433
Re: PIN & TOP WEIGHT?????
« Reply #2 on: June 12, 2003, 07:59:55 AM »
Ya Jeff's recomendations are pretty much the norm.  What ball are you thinking of drilling like this anyways?  I would make sure the top weight doesn't go to far over 3-1/2 ozs' too...depending on the ball you may need a pretty large weight hole.
Logged

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
Re: PIN & TOP WEIGHT?????
« Reply #3 on: June 12, 2003, 02:19:36 PM »
14# Deuce or ReLoaded when it comes out.
I was thinking that I should keep Top between 2.5 & 3 since I am a high tracker PAP is over 5.5 up .75.  This sound right to ya all?

Edited on 6/12/2003 2:25 PM
Logged

livespive

  • Hero Member
  • *****
  • Posts: 4819
Re: PIN & TOP WEIGHT?????
« Reply #4 on: June 12, 2003, 03:06:38 PM »
Yeah I would keep it under 3oz top weight.
I just got a gryphon drilled up not to long ago and was going to get it done stacked, but had 3oz top weight, and my driller said the whole would be huge.
--------------------
Eric T. Spivey, P.E.
 Visionary Test Staff Member
Logged
Pages: [1]
« previous next »