im going to be getting a cell im wanting it to be smooth at the break point not to much snap or over/under rotation thinking like the Pin 3 3/8 from my PAP and under my fingers, place the Mb 3 1/2 from PAP, drilling a weight hole on my PAP back to 1/2 positive side specs are RH,about 425 revs around there and i haven't got my pap exactly but will do soon last time it was 4" over and 1/2" up but what is your alls opion on this

I think that would be too Aggressive personally, and might cause a roll out, especially on the Cell.

I think you should go with a 4 1/2 inch to PAP, pin up, and a pin buffer of 3 1/2 inches (that will smooth out the reaction the most), and MB at 45 degrees.
--------------------
Nothing hits like a Hammer, baby.
Weapons
Anger, Black Widow, Cherry Vibe

High Game- 290
High Series- 701
Average- dwindling around 185-190