win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: I need help  (Read 1044 times)

stormerjip

  • Hero Member
  • *****
  • Posts: 1163
I need help
« on: September 06, 2003, 08:49:56 PM »
I have an origional el nino with a 3-4 inch pin.  The way i was going to drill it the plug would be in the track so i decided to drill it a different way.  the pin and cg on the ball are in line but the mb is offset to the left about an inch.  I was thinking of drilling it with the pin above ring and the cg kicked out a litte and the mb in my center of grip  what kind of reaction would this give.
Logged
show no mercy, kill the wounded, eat the dead

 

Strider

  • Hero Member
  • *****
  • Posts: 6751
Re: I need help
« Reply #1 on: September 07, 2003, 02:23:23 PM »
With an average PAP, that would make the pin 4.5-5" from your PAP with the MB stacked below.  Sounds like a classic skid snap drilling.

I have several balls with plug work in the track.  If you have a good pro shop, don't worry about it.  I never wanted it in the past, but now I don't worry about it so much.
--------------------
Penn State Proud ......THB with loft
Logged
Pages: [1]
« previous next »