win a ball from Bowling.com

Author Topic: Drilling the pin out?  (Read 3517 times)

johns811

  • Hero Member
  • *****
  • Posts: 1095
Drilling the pin out?
« on: July 01, 2020, 07:05:22 AM »
I'm thinking of laying out a ball that puts the pin in the ring finger. Using finger grips, do you position the pin right in the center of the hole/bit? I was going to position the pin to the right edge of the hole guessing of the pin pitch is 0, the ring finger being 3/8" right the bit would remove it all, the holes would not cross paths. Or maybe the pin hole is so small it won't matter and just center the bit.

 

itsallaboutme

  • Hero Member
  • *****
  • Posts: 2006
Re: Drilling the pin out?
« Reply #1 on: July 01, 2020, 12:09:31 PM »
Pin in the center of the hole in case there are any voids around the pin.

johns811

  • Hero Member
  • *****
  • Posts: 1095
Re: Drilling the pin out?
« Reply #2 on: July 01, 2020, 01:07:24 PM »
Pin in the center of the hole in case there are any voids around the pin.

thanks, didn't consider that