win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: AI Drill Question  (Read 1000 times)

fishbowler

  • Hero Member
  • *****
  • Posts: 1259
AI Drill Question
« on: December 22, 2005, 01:58:24 AM »
hey I got an AI in a trade.  the pin is right above the ring and the cg is right below the ring.  onlt a 1.5 inch pin.  no wt holes.

I would like it to finish harder.  is there any wt hole that will help me accomplish this with this drilling??  thanks
--------------------
"I'd quit this game if I thought anyone would give a damn!"
Logged

 

MegaMav

  • Hero Member
  • *****
  • Posts: 3409
Re: AI Drill Question
« Reply #1 on: December 22, 2005, 10:17:38 AM »
if its not finishing hard enough, maybe you're using it on a condition with less oil than it is intended to be used on.
Logged

fishbowler

  • Hero Member
  • *****
  • Posts: 1259
Re: AI Drill Question
« Reply #2 on: December 22, 2005, 10:27:21 AM »
naw, its med oil, but the backend is just so mild arcy that I though if I could get it to "kick" a little more on the end it would be killer.  can shoot a 225 with ease with ball but no higher.  too many corners.
--------------------
"I'd quit this game if I thought anyone would give a damn!"
Logged
Pages: [1]
« previous next »