win a ball from Bowling.com
« previous next »
Pages: 1 [2]

Author Topic: RESULTS: The ONE & Hot Water Treatment  (Read 7750 times)

Ramtart

  • Hero Member
  • *****
  • Posts: 1658
RESULTS: The ONE & Hot Water Treatment
« on: March 10, 2006, 03:46:11 AM »
Hey guys, just wanted to let you know the results after I put The One in a
pale of Hot Water for 15 minutes. I have two of them, but the one I dipped
in hot water is scuffed at approximately 800 grit surface. I decided to do
this, because of its' oil absorption capabilities as advertised.

Ball had about 35-40 games on it before the treatment.

When I came back after about 15 minutes, you could see the oil floating to
the top. I removed the ball and it was pretty greasy hehe.

I dried it off with a towel and emptied the bucket. Man you could smell the
oil. I had to wash the bucket with some detergent hehe.

Results on the lanes 30 minutes later during league:
After a few shots, I noticed a considerable difference overall.
The ball was reading the mids better and I saw new life in its' backend reaction.
I noticed a lot of flare as well.

I guess it is mission accomplished. I have done the Hot water treatment with some of my other equipment and it has worked well so far.

If you are hesistant to put The One in Hot Water, I hope this report helps you in getting a better picture of what happens during this process.

Take care everyone,
Ram
--------------------
Food is good for you!

Edited on 3/10/2006 11:46 AM
Logged

 

bowlingmaniac017

  • Hero Member
  • *****
  • Posts: 1686
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #16 on: March 11, 2006, 12:28:14 PM »
I thought you had to wait at least 24 hours to roll the ball after you do the hot water treatment... is this not true? I thought I read someone that it would crack if you didnt.
Logged
Mike

charlest

  • Hero Member
  • *****
  • Posts: 24524
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #17 on: March 12, 2006, 06:15:10 AM »
quote:
i just used the sink the last time i did this, and that was a while ago with an unbelieveably soaked zone pro azure.. brought her right back to life.. mom wasn't happy with oil in the sink though so i dont reccomend that hahaha
--------------------
When all else fails?STRAP THE LANE!


No body would be happy with it. You're supposed to put in a pail!
--------------------
"...for advice is a dangerous gift, even from the wise to the wise...."
J. R. R. Tolkien


Edited on 3/13/2006 2:47 PM
Logged
"None are so blind as those who will not see."

802dave

  • Full Member
  • ***
  • Posts: 232
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #18 on: March 13, 2006, 09:56:03 AM »
Do you know if the hot water and dawn treatment will work for any reactive?

How about an old Columbia Aftershock?  I've shot a couple 300's with it and now it seems dead...

I'm thinking about buying The One and the Big One; I've been concerned about how long the coverstocks will last; if the hot water & dawn treatment brings them back to life, then that takes care of my concern.

Thanks!
Dave
Logged

scotts33

  • Hero Member
  • *****
  • Posts: 8452
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #19 on: March 13, 2006, 10:14:32 AM »
It should.  

So far, I see no loss in reaction with my The One.  Has now over 75 games on it.  Usually by now I'd see some reaction loss.  I use a good cleaning regimen.  I think with any new ball that's key.
--------------------
Scott

Logged
Scott

Crankenstein300

  • Hero Member
  • *****
  • Posts: 1296
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #20 on: March 13, 2006, 11:27:06 AM »
quote:
Do you know if the hot water and dawn treatment will work for any reactive?


Works great. I did it to my Shock Trauma, Infernos, and a Super Charge with very noticeable results to all of them.
Logged

802dave

  • Full Member
  • ***
  • Posts: 232
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #21 on: March 13, 2006, 11:39:04 AM »
I haven't been the best on keeping them clean; I've recently started using diluted Simple Green on my 3D Superhook and there's been a noticable difference - when I clean it before I put it away, the next time out it works very well; the one time I didn't clean it and used it the next day, it wouldn't finish nearly as hard.

I need to try the pale method on them all!  Maybe it'll revive the Big Bully as well.

Thanks!
Dave
Logged

squeeds

  • Jr. Member
  • **
  • Posts: 32
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #22 on: March 30, 2006, 12:51:14 PM »
I agree with everyone here.  My Nitro r squared still hooks very nice, been using it for 10 years, and also do it to my Roto-Grip Assault.  Usually I use Renew-It after I'm done.  
I have NEVER taped the holes up on either ball when I soak them.  I usually shoot for around 120 degrees, which is just a bit hotter than tap (ours really doesn't get that hot).  Usually I go 3 tablespoons of simple green in a 1.5 qt bucket, fill it up about half way, and put the ball in holes facing down.  Also use a very light scotchbrite pad over the whole thing to remove any belt marks.  I rinse the ball, and let dry at least overnight.
Logged

rackattack

  • Hero Member
  • *****
  • Posts: 994
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #23 on: March 30, 2006, 02:16:58 PM »
I'm with sqeeds.I don't bother plugging the holes either.I just put a little dawn in the dish pan and let the hot tap water slowly drizzle over the ball until the pan is full,let it sit for 10-15 minutes and go over it with a white scuff pad.Second step is to pull it out, set it on a ball cup and let the hot water drizzle on it while wiping the ball til the water runs clean.Last step is to dry the ball then let it sit with holes down til dry.
Whole operation is 20-30 min to clean and 2-3 hours to dry.
I do this evey 30 games or so and there is never a heavy build up.
I have done this to all my equipment with no negative results.
--------------------
President and CEO Visionite Stormy Buzzwick LTD
Logged

rackattack

  • Hero Member
  • *****
  • Posts: 994
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #24 on: March 30, 2006, 03:50:00 PM »
Lefty,
All the time.I just use a soft rag instead of the scrub and re-apply polish when dry.
--------------------
President and CEO Visionite Stormy Buzzwick LTD
Logged

BigWillyStyle

  • Hero Member
  • *****
  • Posts: 897
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #25 on: March 30, 2006, 04:08:12 PM »
I did this with my Morich Onslaught (light load particle pearl cover for those who don't know), that had about 100 games on it. I needed to do a complete resurface, so a few people on here said that it's best to leave it dull when I soak the ball, so it could clean out the broken particles better. I did the hot water treatment to it (and an old Columbia300 Reaction ARC), with very mixed results. The Reaction ARC gained a lot of it's original power, while the Onslaught seemed to lose a bit of overall reaction (seemed to not read the mids as well). I decided to give it a high gloss, and have now been using it for 2nd shifts with excellent results, but am still a little saddened that it lost a bit of hook. I know that I did it correctly, because the ARC came out OK...maybe that cover on the Onslaught isn't good to do this trick with...? Any insight from anyone who has done this with an Onslaught (or other equipment with the same cover) would be greatly appreciated.

Big Willy Style

PS...I didn't mean to hijack your post Ram...was giving my experience and decided to ask for advice as well...  
--------------------
Just my $0.02; so take it for what the Foreign Exchange values it at!
"I was raised by a cup of coffee..."
***This message brought to you by the A.O.B.U.B.O.A. (Assembly Of Back-Up Bowlers Of America) which is now taking applications***  
Honorary Member of the F.O.S. (and also the best back-up bowler the Saws have ever had)!
Logged

Ramtart

  • Hero Member
  • *****
  • Posts: 1658
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #26 on: April 10, 2006, 09:43:05 AM »
Hey guys, just wanted to give an update.

I gave my other The One (This one is OOB Polished)
the hot water treatment as well

It worked well and the ball is as tacky as ever!
Took it out for a spin last night at a mini-tourney
and from the looks of it, hasn't lost its' great reaction.

Thanks again guys!
Ramtart
--------------------
Food is good for you!
Logged

jnobcrew

  • Jr. Member
  • **
  • Posts: 72
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #27 on: April 10, 2006, 01:43:11 PM »
That's great news.  I have tried other balls, but have been hesitant to try the BIG ONE.  I should try it, have a couple tourneys soon and wouild like the most dangerous ball possible.
Logged

Joebowler98

  • Sr. Member
  • ****
  • Posts: 328
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #28 on: April 12, 2006, 12:18:29 AM »
When you say HOT water how hot do you mean??? I tried this on a ball a year or so ago. But i was afraid to get the water too hot? I noticed a little better reaction on the pearl reactive i did that to.

Thanks!
Tim
Joebowler98
Logged

Monster Stitch

  • Hero Member
  • *****
  • Posts: 1490
Re: RESULTS: The ONE & Hot Water Treatment
« Reply #29 on: April 12, 2006, 10:16:50 AM »
You can boil water, super hot and pour it into a bucket where the ball is.
Works great.
Logged
Pages: 1 [2]
« previous next »